ADAPTATION OF EXISTING BREAKWATERS TO SEA LEVEL RISE - OVERTOPPING EFFECT
ICCE 2012 Cover Image
PDF

Keywords

Maritime breakwater
Overtopping rate
Reinforced structure
Structure's crown-wall

How to Cite

ADAPTATION OF EXISTING BREAKWATERS TO SEA LEVEL RISE - OVERTOPPING EFFECT. (2012). Coastal Engineering Proceedings, 1(33), structures.18. https://doi.org/10.9753/icce.v33.structures.18

Abstract

This paper describes the wave overtopping measurements of small scale maritime breakwater in sea level rise scenarios which are supposed in French program GICC (Gestion et Impacts du Changement Climatique - Management and Impacts of Climate Change). Many reinforced solutions have been carried out with the purpose to conserve the overtopping rate; among them, the influence of raising freeboard crest is analyzed. The test results are compared with results from literature and with the empirical models presented by Owen (1980), Van der Meer (1998) and Besley (1999). Since then, a guideline is proposed for a better prediction of wave overtopping with various types of high crown-wall.
PDF

References

Besley P., 1999. Wave overtopping of Seawalls. Design and Assessment Manual. Hydraulics research Wallingford. R&D Technical Report W178, ISBN 1 85705 069 X.

Briganti, R., Bellotti, G., Franco, L., De Rouck, J., Geeraerts, J., 2005. Field measurements of wave overtopping at the rubble mound breakwater of Rome-Ostia yatch harbour, Coastal Engineeing 52, pp. 1155-1174.http://dx.doi.org/10.1016/j.coastaleng.2005.07.001

Bruce, T., Van der Meer, J.W., L. Franco, Pearson, J.M., 2008. Overtopping performance of different armour units for rubble mound breakwaters, Coastal Engineering Volume 56, Issue 2, February 2009, pp. 166-179.http://dx.doi.org/10.1016/j.coastaleng.2008.03.015

CIRIA, CUR, CETMEF, 2009. Guide enrochement. L'utilisation des enrochements pour les ouvrages hydrauliques. Version français du Rock Manual, CETMEF, Compiègne.

EurOtop, 2007. Wave Overtopping of sea defences and related structures - Assessment manual. Archive for Research and Technology on the North Sea and Baltic Coast.

Frens, A. B., 2007. The impact of placement method Antifer-block stability. MSc-thesis, Delf University of Technology.

Geeraerts, J., Troch, P., De Rouck, J., Willems, M., Franco, L., Bellotti, G., Briganti, R., 2004. Wave overtopping at Ostia yacht harbour breakwater: comparison between prototype and model tests in 2D and 3D. Proc. 29th ICCE, Lisbon, Portugal, 19-24 September 2004. pp. 4288-4300.

Lykke Andersen, T., Burcharth, H.F., Gironella, X., 2011. Comparison of new large and small scale overtopping tests for rubble mound breakwaters, Coastal Engineering 58, pp. 351-373.http://dx.doi.org/10.1016/j.coastaleng.2010.12.004

Owen, M.W., 1980. Design of seawalls allowing for wave overtopping. Hydraulics Research, Wallingford, Report No. EX 924, UK.

TAW, 2004. Dutch Technical Advisory Committee on Flood Defence. Technical Report on Wave run-up and Wave overtopping at dikes. Delft, the Netherlands.

Troch, P., Geeraerts, J., Van de Walle, B., De Rouck, J., Van Damme, L., Allsop, W., Franco, L., 2004. Full-scale wave overtopping measurements on the Zeebrugge rubble mound breakwater, Coastal Engineering 51, pp. 609-628.http://dx.doi.org/10.1016/j.coastaleng.2004.06.004

Van der Meer, J. W., 1998. Wave Run-Up and Overtopping, Chapter 8 in: "Seawalls, dikes and revetments".

Authors retain copyright and grant the Proceedings right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this Proceedings.