AbstractStepped revetments are multi-functional coastal structures o ering protection against flooding. Despite the fact that these structures have been implemented for more than 60 years, comprehensive design guidance is lacking. Previous research studied overtopping of stepped revetments with slopes ranging between 1:1 to 1:4. To address the knowledge gap of predicting overtopping of stepped revetments with gentler slopes, this paper presents results of physical model tests for a 1:6 sloped stepped revetment with step heights of 0.05 m. The tests were conducted in a 110 m long, 2.2 m wide and 2.0 m deep wave flume. A fit through the overtopping results is compared with the reference curve for a smooth slope of EurOtop (2016), which allows the determination of the influence factor for roughness ( gamma_f ) of the stepped revetment. A value of gamma_f = 0.74 (r^2 of 0.94) is proposed to be used in combination with the overtopping prediction formula of EurOtop (2016) for slopes under breaking wave conditions. The results of the study indicate a high slope dependency for gamma_f .
EurOtop (2016). Manual on wave overtopping of sea defences and related structures. An overtopping manual largely based on European research, but for worldwide application. Van der Meer, J.W., Allsop, N.W.H., Bruce, T., De Rouck, J., Kortenhaus, A., Pullen, T., Schuttrumpf, H., Troch, P. and Zanuttigh, B., www.overtopping-manual.com.
Goda, Y. and Kishira, X. (1976). Experiments on irregular wave overtopping characteristics of low crested seawalls. Technical Note of PARI, 242(1-29).
Heimbaugh, M. S. (1988). Coastal engineering studies in support of virginia beach, virginia, beach erosion control and hurricane protection project: Report 1, physical model tests of irregular wave overtopping and pressure measurements. Technical Report Volume 88-1, CERC.
Kerpen, N. B., G. N. and Schlurmann, T. (2014). Experimental investigations on wave overtopping on stepped embankments. In 5th International Conference on Application of Physical Modelling to Port and Coastal Protection. (2):262-269.
Kerpen, N. B. (2017). Wave-induced Responses of Stepped Revetments. PhD thesis, Leibniz University Hannover.
Kerpen, N. B. and Schlurmann, T. (2016). Stepped revetments revisited. In Proceedings of the 6th International Conference on the Application of Physical Modelling in Coastal and Port Engineering and Science (Coastlab16). Ottawa, Canada, May 10-13, 2016.
Mansard, E. P. D. and Funke, E. R. (1980). The measurement of incident and reflected spectra using a least squares method. In Coastal Engineering 1980, pages 154-172.
Saville, T. (1955). Laboratory data on wave run-up and overtopping on shore structures. Technical Report Vol. 64, U.S. Beach Erosion Board, Washington D.C.
Takayama, T., Nagai, T., and Nishida, K. (1982). Reduction of wave overtopping due to low crested seawalls. Technical Report 21(2):151-206, The Port and Harbour Research Institute. [in Japanese].
Van Steeg, P., Joosten, R. A., and Steendam, G. J. (2018). Physical model tests to determine the roughness of stair shaped revetments. In 3rd International Conference on Protection against Overtopping, 6-8 June 2018, U.K.
Van Steeg, P., Wolters, G., and van Gent, M. (2012). Invloedsfactor voor ruwheid van een getrapt talud bij golfoverslag bij dijken: Verslag fysieke modeltesten en analyse. Technical Report 1206984-000-HYE- 0006, Deltares, Delft, The Netherlands. [in Dutch].
Ward, D. L. and Ahrens, J. P. (1992). Overtopping rates for seawalls. Technical Report CERC-92-3, U.S. Army Corps of Engineers.
Xiaomin, W., Liehong, J., and Treuel, F. M. (2013). The study on wave run-up roughness and permeability coefficient of stepped slope dike. In Proceedings of the 7th International Conference on Asian and Pacific Coasts (APAC 2013).